Hand tool list
*Woodworking Basics-Peter Korn 145078 - $19.95
Tage Frid Woodworking Book - 144428 $29.95 list
*Marking - Marking gauge - Wheel type preferred - 141015 $21.99 Or 143531 - $10.99
*Square - Required item (bring your own but it should be pretty darn square!)
Engineers Square - 141015 - $14.99
Or Combination Square - 06R12 - $72.99 (if you splurge on one thing this is it!)
*Rule Required - 6 inch- some kind such as 140656 - $5.99
Or a one foot rule of similar type/quality. PLUS a tape measure(*).
#4 Stanley - such as 123401 - $57.99 (or whatever you have or can get on Ebay - get a Bailey if you bid and don’t pay more than about $18 plus shipping)
Rabbit Plane - Good one is #143674 - This is a wooden plane - rather cool! - $29.99
Perhaps you can find one on Ebay or ?? A Stanley #190 would be an alternate or a #78. Lots of these on eBay. Most are in the $20 range.
*Chisels - Required
Some kind of small (4 or 5 piece) set - I recommend the Marples - 111165 - $32.99
And some kind of mallet - check out those at Woodcraft but please wait til you try mine. A useful choice would be a medium sized dead blow hammer.
#80 Stanley - 16K60 = $35.99 (Not required.)
Clamps - Two clamps capable of 15” clamping - and Two capable of 24” clamping. A good compromise is the 141291 Clamp heads (need 4 clamps). You make them any length you want. We can do prepare them in class if you can’t get them done ahead of time.
*03A21 Required Honing Guide - $9.99
Water Stone - Good to have one or the other but you can share/use mine/or use shop’s
08T41 800/4000 waterstone $25.99 or 818263 1000/4000 waterstone $54.99
*Dovetail saw =Required - You’ll tune up this inexpensive saw - 15Q01($7.99) or if you wish, here’s one that requires no tuning at all -12F34 Duzaki Japanese Saw $28.99
Kreg Jig - Not required but very useful to anyone - Pocket Hole Set - 128152- $60 if you don’t have one, you’ll have to share mine in class.
Note: Numbers such as 145078 refer to Woodcraft SKU.